MartinLogan 10 Specifications download pdf (Page 8)

8 Connections and Control Settings

AC Power Connection Replacing the Fuse

The power cord should be firmly inserted into any conve-

nient AC wall outlet. The CW10 also integrates a signal

sensing power supply that automatically switches off after

sensing no music signal for several minutes (this will cause

the status LED to turn off).

Your CW10 subwoofer is wired for the power service sup-

plied in the country of original consumer sale. The AC power

rating applicable to a particular unit is specified both on the

packing carton and on the serial number plate attached to

the subwoofer.

If you remove your CW10 subwoofer from the country of

original sale, be certain that AC power supplied in any sub-

sequent location is suitable before connecting and operating

the subwoofer. Substantially impaired performance or severe

damage may occur to the CW10 subwoofer if operation is

attempted from an incorrect AC power source.

If the fuse in your CW10 should require changing, turn off

and unplug your CW10 before removing the fuse. Replace

the bad fuse with a matching T 1.6A L 250V (T 0.8A L

250V if you are in a region using 230V).

Break-In

Our custom made woofers require approximately 50 hours

of break-in at moderate listening levels before their optimal

performance occurs. This will factor in on any critical listening

and judgment.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

MartinLogan 10 Specifications Page 8