MartinLogan 10 Specifications download pdf (Page 13)

Troubleshooting 13

NoOutput

• Check that all your system components are turned on.

• Check that the master power switch adjacent to the AC

receptacle is set to 'Auto On'.

• Check your wires and connections.

• Check all interconnecting cables.

• Make sure the level control is not turned down.

• Turn off and unplug the CW10 and check the fuse

near the AC power cord receptacle on the back. If the

fuse has blown, replace the bad fuse with a matching

T 1.6A L 250V fuse (T 0.8A L 250V if you are in a

region using 230V).

• If the problem persists, contact your dealer.

MuddyBass

• Check placement. Try moving the subwoofer closer to

the front and side walls.

• Decrease the level.

• Check your processor setup.

• If the problem persists, contact your dealer.

HumsorUnusualSounds

• Turn the CW10 off, unplug all signal inputs, turn the

CW10 back on and turn up the level. If the problem

disappears, the hum is originating elsewhere in your

system.

• Connect the CW10’s AC connection to the same AC cir-

cuit as the pre amp.

• If the problem persists, contact your dealer.

Troubleshooting

trouBleshootIng

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

No comments

MartinLogan 10 Specifications Page 13