MartinLogan Dynamo 700 Specifications download pdf (Page 10)

10 Connections and Control Settings

AC Power Connection

WARNING! The power cord should not

be installed, removed, or left detached from

the subwoofer while the other end is con-

nected to an AC power source.

The IEC power cord should be firmly inserted into the AC

power receptacle on the rear connection panel of the

Dynamo, then to any convenient AC wall outlet. The Dynamo

also integrates a signal sensing power supply that automati-

cally switches off after sensing no music signal for several

minutes (this will occur when the power switch is set to 'Auto').

Your Dynamo subwoofer is wired for the power service

supplied in the country of original consumer sale. The AC

power rating applicable to a particular unit is specified

both on the packing carton and on the serial number plate

attached to the subwoofer.

If you remove your Dynamo subwoofer from the country of

original sale, be certain that AC power supplied in any

subsequent location is suitable before connecting and oper-

ating the subwoofer. Substantially impaired performance

or severe damage may occur to the Dynamo subwoofer if

operation is attempted from an incorrect AC power source.

Replacing the Fuse

If the fuse in your Dynamo 700 should require changing,

turn off and unplug your Dynamo 700 before removing

the fuse. Replace the bad fuse with a matching T 3.15A L

250V (T 1.6A L 250V if you are in a region using 230V).

Break-In

Our custom made woofers require approximately 50 hours

of break-in at moderate listening levels before their optimal

performance occurs. This will factor in on any critical listen-

ing and judgment.

Optional Wireless Connection

The Dynamo 700 incorporates a wireless receiver for

use with the MartinLogan SWT-1 Subwoofer Wireless

Transmitter (sold separately and available from your autho-

rized dealer or the Xtatic shop at www.MartinLogan.com).

To establish a wireless connection, connect a transmitter to

your electronics and follow these two easy steps.

1. Press the Dynamo 700’s sync button once. The LED will

blink quickly.

2 Press the sync button on the SWT-1 transmitter once.

The LED will blink quickly. If pairing has completed suc-

cessfully both LEDs will stop blinking and remain on.

Please note: If a link is not established after 10

seconds this transmitter’s LED will start blinking slowly.

Repeat both steps.

WARNING! When operating wirelessly this subwoofer

may be susceptible to RF interference in the 2.4GHz

bandwidth from microwave ovens and wireless devices

such as WiFi systems, video game consoles, cordless

telephones, blue tooth devices, and baby monitors.

Generally, this issue (popping noises) is easily resolved

by physically separating problematic devices from one

another—adistanceaslittleastwofeetwilloftenalleviate

the interference. In the case of microwave ovens, the inter-

ference will only occur when the microwave is operating.

Figure 6. Establishing a connection between the Dynamo 700 and the

SWT-1 Subwoofer Wireless Transmitter (sold separately).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

MartinLogan Dynamo 700 Specifications Page 10

Comments to this Manuals

Related products and manuals for Subwoofers MartinLogan Dynamo 700