MartinLogan Dynamo 700 Specifications download pdf (Page 10)

10 Connections and Control Settings

AC Power Connection

WARNING! The power cord should not be

installed, removed, or left detached from

the subwoofer while the other end is con-

nected to an AC power source.

The IEC power cord should be firmly inserted into the AC

power receptacle on the rear connection panel of the

subwoofer, then to any convenient AC wall outlet. The sub

also integrates a signal sensing power supply that automati-

cally switches off after sensing no music signal for several

minutes (this will occur when the power switch is set to 'Auto').

Your subwoofer is wired for the power service supplied in

the country of original consumer sale. The AC power rat-

ing applicable to a particular unit is specified both on the

packing carton and on the serial number plate attached to

the subwoofer.

If you remove your subwoofer from the country of original

sale, be certain that AC power supplied in any subsequent

location is suitable before connecting and operating the

subwoofer. Substantially impaired performance or severe

damage may occur to the subwoofer if operation is attempt-

ed from an incorrect AC power source.

Replacing the Fuse

If the fuse in your subwoofer should require changing, turn

off and unplug your subwoofer before removing the fuse.

Replace with a matching fuse.

Break-In

Our custom made woofers require approximately 50 hours

of break-in at moderate listening levels before their optimal

performance occurs. This will factor in on any critical listen-

ing and judgment.

Optional Wireless Connection

The Dynamo 1000W and 700W subwoofers incorporate

a wireless receiver for use with the MartinLogan SWT-2

Subwoofer Wireless Transmitter. To establish a wireless

connection, connect a transmitter to your electronics and

follow these two easy steps.

1. Press the subwoofer’s sync button and hold for 3 sec-

onds. The LED will blink quickly.

2 Press the sync button on the SWT-2 transmitter and hold

for 3 seconds. The LED will blink quickly. If pairing has

completed successfully both LEDs will stop blinking and

remain on. Please note: If a link is not established

after 30 seconds this transmitter’s LED will start blinking

slowly. Repeat both steps.

WARNING! For best performance we recommend that

the SWT-2 wireless transmitter not be placed on the floor.

WARNING! When operating wirelessly this subwoofer

may be susceptible to RF interference in the 2.4GHz

bandwidth from microwave ovens and wireless devices

such as WiFi systems, video game consoles, cordless

telephones, blue tooth devices, and baby monitors.

Generally, this issue (intermittent sound or slight popping

noises) is easily resolved by physically separating prob-

lematic devices from one another—a distance as little as

two feet will often alleviate the interference. In the case of

microwave ovens, the interference will only occur when

the microwave is operating.

Figure 6. Establishing a connection between the subwoofer and the

SWT-2 Subwoofer Wireless Transmitter (included).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

MartinLogan Dynamo 700 Specifications Page 10

Comments to this Manuals

Related products and manuals for Subwoofers MartinLogan Dynamo 700