MartinLogan Source Speakers Specifications download pdf (Page 6)

MartinLogan'sengineeringanddesignteamdeveloped

the Dynamo 500 for easy setup and system integra-

tion. Before beginning to connect your Dynamo 500,

please review the controls discussed in the last section.

An understanding of these will help speed you along as

you connect and integrate your Dynamo 500 with your

system. All signal connections are done on the rear con-

nections panel of the Dynamo 500. Make certain that all

of your connections are tight.

WARNING! Turn your Dynamo 500

subwooferto'Off'beforemakingor

breaking any signal connections!

2-Channel Mode

This setup is recommended if your Dynamo 500 will be

used in a 2-channel system with main speakers playing full

range.WhenasignalisconnectedtotheDynamo500’s

left/rightinputsandthecrossoverswitchissetto'Variable

(L&RIn),theDynamo500’sinternallowpassfilteris

active.

If you will be using your system for both 2-channel and

multi-channel listening we recommend connecting the

Dynamo500asrecommendedin'Multi-Channel/LFE

Mode'onthenextpage.Somemodernreceiversand

processors allow users to route left and right channel

low-frequencyinformation,inadditiontodiscreteLFEinfor-

mation, through the LFE output.

Signal Connection (see figure 2):

1 Connect the left and right outputs of your preamplifier

to the left and right inputs of the Dynamo 500 using

qualityRCAinterconnects.Ifyourpreamplifieronlyhas

one set of outputs you may need to obtain Y adapters

from your dealer.

Recommended Control Settings (see figure 3):

Setthecrossoverswitchto'Variable(L&RIn)'

Setthe'LowPassFilter'knobtoapproximately

70%of

yourloudspeakerslowestfrequencyresponse.

3 Whileplayingmusicwithbasscontent,turnthelevel

controlupuntilthemusichasdeepextendedbass,

being careful to avoid levels that become overwhelming.

4 Try the phase control in different settings until the best

blending is obtained.

ConneCtIons and Control settIngs

Before Connecting the Dynamo

6ConnectionsandControlSettings

Figure 2. Signal connection for 2-channel mode.

Figure 3. Control settings for 2-channel mode.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comments to this Manuals

No comments

MartinLogan Source Speakers Specifications Page 6

Comments to this Manuals

Related products and manuals for Soundbar speakers MartinLogan Source Speakers